Download and install Manual Update Galaxy Note 10.1 N8000 with Official Kitkat 4.4.2 Android Firmware

 

Procedure to Update Galaxy Note 10.1 N8000 with Kitkat 4.4.2 Firmware:

• Download Odin and Firmware Package of Kitkat 4.4.2 from here to your computer. Once downloaded, extract both the zip files in your computer.

• Turn Off your device so that it can be entered in the download mode. Download mode in Galaxy Note 10.1 can be entered by holding the Volume Down button + the Home key button (the middle button). While holding these both buttons, you need to switch ON your device. If the tablet enters in the normal mode, you need to retry the process of entering the device in the Download mode.

• Open Odin in your computer and connect your Galaxy Tab 10.1 device to the computer while in the download mode to see ID: COM section turns Blue. Once it turns blue, it will indicate that all the required drivers are installed successfully and select below mentioned files in Odin.

- Add AP_N8000XXUDND5.tar.md5 to AP
- Add BL_N8000XXUDND5.tar.md5 to BL
- Add MODEM_N8000XXUDND2.tar.md5 to CP
- Add CSC_OXA_N8000OXADND5.tar.md5 to CSC

• Make sure re-partition is NOT ticked in Odin. Once the above files are selected, click on “Start” to start the process of firmware update. It will take around 3 -4 minutes for applying the update. Once the firmware is applied, tablet will be rebooted automatically.

• It will take 5 – 7 minutes for loading all the apps and applying the update in the device. Don’t disconnect the device from Odin till you see the home screen in your tablet. Once you see the home screen, you need to disconnect the device from computer.

• Head over to the path “Settings > More > About Tablet” to check out the latest version of firmware which will be mentioned as Kitkat 4.4.2 OS with the version detail as XXUDND5.

Note:  If at all your Galaxy Note 10.1 N8000 gets in the boot loop sequence then you need to turn off the device and then reapply the update from the start. To turn off you can long press the power button.

So there you go, you have now successfully applied the latest firmware update of Kitkat 4.4.2 Android OS in the tablet manually. Do let us know in the comments section just in case if you face any issues in the process of firmware update.